› SPC and Acceptance Sampling
Quality Digest   |  Sun, 07/25/2004

In the last 5 years, there is not much talk about “Acceptance Sampling”. Very few articles in this subject are published in journals. On the other hand, SPC techniques are discussed in every Quality Magazine, many published papers and in conferences. Is there any Correlation to these two trends?

Has the development and rapid recognition of Statistical Process Control techniques have made the "Acceptance Sampling" almost obsolete?

Comments

07/02/2001 - 09:11 am — Quality Digest

guest 7/2/2001

I found a web site which has calibration procedure software. As part of the actual procedures are steps to disassemble, clean, lubricate and reassemble the device as well as the actual calibration of it. Some of the reference documents in the procedure are NIST Handbook 150, NIST Technical Note 1297 and ANSI/NCSL Z540-1. The website is WWW.pixi.com/~techcom/calibrationprocedure.htm. Hope this works for you or at least helps you some.

You can create content!

  • Classifieds
  • File Share
  • Forum Topic
  • Events
  • Links

Sign In to get started!

Quality Information