Budget is always an issue, even in large companies. Finding a calibration lab to check the thread gages you make is likely the most cost-effective solution. An accredited lab is preferred if there is one near you, also ask your current calibration provider.
The cycle to have the gage rechecked/recalibrated will depend on the use it has. Heavy use in a hard environment (tyipcal in machine shops) means it gage needs to be checked more often. For functional checks only, using the plug gage is a quick and reasonable way to have a feel for its wear. However, ring gages, like jo blocks (gage blocks to a Metrologist) can wear over time, so a periodic check by an outside party (like your calibration provider) is necessary to keep track of that.
Community metadata Could not be loaded. No pre-configured community forum parent found for the incoming fid: . You need to add this forum into custom_code/community.sql
Send to friend
Comments
hershal 7/25/2002
Budget is always an issue, even in large companies. Finding a calibration lab to check the thread gages you make is likely the most cost-effective solution. An accredited lab is preferred if there is one near you, also ask your current calibration provider.
The cycle to have the gage rechecked/recalibrated will depend on the use it has. Heavy use in a hard environment (tyipcal in machine shops) means it gage needs to be checked more often. For functional checks only, using the plug gage is a quick and reasonable way to have a feel for its wear. However, ring gages, like jo blocks (gage blocks to a Metrologist) can wear over time, so a periodic check by an outside party (like your calibration provider) is necessary to keep track of that.
Hope this helps.
Hershal