I am looking for some info on a method of inspecting Inside Diameters using a molding technique.I am told it is a simple method using a liguid plastic type material and letting it harden it is then removable making a mold of the inside of certain parts allowing the measurement to be obtained by a comparator. Anyone out there heard of it or familiar with it?
Send to friendSign In to get started!
Comments
forrestbreyfogle 5/6/2005
INITIAL POSTING: "What techniques can I use to effectively engage middle management in Six Sigma projects/deployment?"
RESPONSE: It is more desirable to create a system where projects are pulled for creation, as opposed to being pushed into the system. If we need to work at increasing management's interest in project creation, I view this a push system for project creation.
I like to have 30,000-foot-level metric accountability by management, where these metrics address operational business needs tracked over time without calendar boundaries.
Goals can then be set for these metrics. Targeted metrics for business' goal success are to demonstrate a statistically significant improvement in time; i.e., could be in management's performance plan.
To achieve the desired shift in the 30,000-foot-level metric, one will need to do something different within the process. Six Sigma projects can provide the mechanism for this to occur; i.e., performance metrics pull for the creation of projects.
Contact me off-line if you would like to discuss further.
Forrest Breyfogle
Six Sigma Moderator
forrest@smartersolutions.com
512-918-0280
www.SmarterSolutions.com