I have been using the 3 wire method and formula per Van Keuren Handbook for many years to check P.D. without a taper sine block. Machinerys Handbook and formula yield similar results without a taper sine block. ASME B1.20.5-1991 appendix shows a taper sine block with a formula that I cannot really figure out, but I guess is the best method. Can someone help me work thru this ASME formula? The book does not give an example.
Send to friendSign In to get started!
Comments
kevinr 7/14/2004
As a start I would recommend searching the internet. If you are looking for texts, Quality Press at www.asq.org is a good bet, or if you are looking for how to write a (ISO 9001) manual you can do worse than purchase my book from Quality Press, ISO 9001:2000, A Practical Quality Manual Explained, which will give you the full text of an ISO compliant manual.